BILGE PUMP, RULE 1100 GPH AUTO 12v, WITH PUMP CHECK

Higher Flow — optimized impeller to provide up to 10% more flow at the same amperage
Auto Sense Intelligence — integral water level sensor controls the pump automatically
Back Up Feature — prevents continuous running if sensor is fouled by debris, pump reverts to 2.5-minute cycle mode
Smaller Footprint — new RuleMate is 2/3 the size of existing model
Built-In Thermal Cut-Off (TCO) — provides added protection for pump & vessel
Back Flow Prevention — reduces the amount of water left over in the bilge, reducing odour and helping keep your bilge cleaner
Hidden Air Vents in the Body — helps prevent air locking in challenging plumbing installations and helps with the check valve
Threaded Discharge — easier installation, easier maintence
Ignition protected
3-year warranty
Dimensions: 4.4”H x 3.5”W x 2.9”D
112 x 88 x 73 mm
RuleMate Next Generation
The new RuleMate bilge pumps operate using an internal level sensor. When water reaches 2″ (5cm), the pump will automatically activate, removing water from the bilge. When the water level reaches 3/8″ (0.9cm) the pump will turn off until the water level rises again. Bilges are not always clean and free from debris. If the level sensor becomes fouled by debris or contaminated water, Rule Mate’s unique back up feature will prevent the pump from entering a run-on condition, protecting the battery while maintaining automatic operation.